Title: Modeling and simulation of agglomeration in turbulent particle-laden flows
Subtitle: A comparison between energy-based and momentum-based agglomeration models
Authors: Almohammed, Naser 
Breuer, Michael  
Language: eng
Subject (DDC): DDC - Dewey Decimal Classification::000 Informatik, Wissen, Systeme
DDC - Dewey Decimal Classification::500 Naturwissenschaften
DDC - Dewey Decimal Classification::600 Technik
Issue Date: 2016
Publisher: Elsevier
Document Type: Article
Source: Enthalten in: Powder technology. - Amsterdam [u.a.] : Elsevier Science, 1967- ; ZDB-ID: 2019938-7 . - Bd. 294.2016, 6, Seite 373-402
Journal / Series / Working Paper (HSU): Powder Technology 
Volume: 294
Page Start: 373
Page End: 402
Publisher Place: Amsterdam
Abstract: 
© 2016 Elsevier B.V. In the present work, the particle agglomeration in shear flows is investigated in the framework of a hard-sphere model with deterministic collision detection employing two different modeling approaches: the energy-based and the momentum-based agglomeration models. The former is further improved concerning the agglomeration conditions. Moreover, the application area of both models is extended towards fully three-dimensional turbulent flows applying the large-eddy simulation technique. Here, the particles are assumed to be rigid, dry and electrostatically neutral and hence only the cohesion due to the van-der-Waals forces is considered. First, the energy-based and the momentum-based agglomeration models are successfully validated based on theoretical results using an existing laminar test case. The numerical results are found to be in close agreement with the theory. Then, both agglomeration approaches are used to investigate the dynamic process of the particle agglomeration in a vertical fully developed turbulent channel flow. A detailed comparison of the results obtained using both agglomeration models is reported. Additionally, the performance of both techniques is examined under the influence of varying normal restitution coefficients of the inter-particle collisions. Furthermore, the influence of the inclusion of three sub-models (the feedback effect of the particles on the fluid, the lift forces and the subgrid-scale model for the particles) on the agglomeration process is studied. The results show that a significantly lower agglomeration rate is observed if the sub-models are considered. Next, the agglomeration models are applied to evaluate the effect of the diameter of the primary particles and the wall roughness on the agglomeration behavior. The reduction of the diameter of the particles leads to a stronger cohesive impulse and hence to a higher agglomeration rate. The wall roughness enhances the particle-particle collisions and slightly increases the number of agglomeration processes leading to higher agglomeration rates. The comparative study clearly indicates that both models predict similar trends of the physical behavior of the agglomeration process, but their results deviate slightly from each other. The most important reasons for the differences observed between the numerical results of both models are discussed. Based on the advantages and drawbacks of both models highlighted in this study, it can be concluded that owing to the reduced necessity of empirical parameters and the slightly more accurate results the momentum-based agglomeration model is superior to the energy-based model.
Organization Units (connected with the publication): Strömungsmechanik 
URL: https://api.elsevier.com/content/abstract/scopus_id/84960171819
ISSN: 00325910
DOI: 10.1016/j.powtec.2015.12.034
Appears in Collections:Publications of the HSU Researchers

Show full item record

CORE Recommender

SCOPUSTM   
Citations

40
checked on Aug 13, 2022

Google ScholarTM

Check

Altmetric

Altmetric


Items in openHSU are protected by copyright, with all rights reserved, unless otherwise indicated.